Sprinkler Repair ArlingtonSprinkler Repair ArlingtonSprinkler head replacement in Arlington generally falls in a $75 to $175 range per visit, depending on head type and count. DFW Sprinkler Repair handles the digging and testing on systems homeowners near Woodland West and Fielder Crossing can't see underground.
| Head type | Typical part cost per head |
|---|---|
| Fixed spray head (pop-up) | $8 – $15 |
| Rotor head (large-area) | $15 – $30 |
| High-efficiency / MP rotator nozzle | $12 – $25 |
| Shrub/riser head | $8 – $18 |
| Minimum service charge (any visit) | $75 |
Sprinkler head types and typical Arlington replacement cost (parts, per head)
A fixed pop-up spray head is the least expensive part, usually $8 to $15. Rotor heads that throw water across a larger radius run $15 to $30 because the internal gear drive costs more. High-efficiency nozzles cost slightly more than standard spray tips. Most single-head repairs in Arlington finish inside one visit, and the $75 minimum covers locating the head, digging it out, swapping it, and running the zone to confirm coverage.
A broken head is often a symptom, not the whole problem. A cracked riser, a clogged nozzle, or low pressure from a separate leak can all mimic a bad head. A proper visit tests the zone, confirms the actual failure, and fixes only what's failed. Replacing multiple heads on the same trip lowers the per-head cost because the diagnostic and travel time is already covered under the base charge.
If a mower or car has snapped a head off at the fitting, the buried threaded connection sometimes cracks too. That adds a coupling or short pipe section, pushing a single repair toward the $150 to $175 range. Straightforward pop-up swaps stay near the minimum. A technician can see this only after exposing the head, which is why an honest ballpark is given on site rather than blind over the phone.
Many Arlington systems are 8 to 20 years old and start failing one head at a time. When several heads on the same zone are worn, replacing them together is often smarter than repeat trips. This is not an automatic upsell to a whole new zone — a good technician shows the worn parts in the yard and lets the homeowner decide. The real break gets fixed first.
Arlington's clay-heavy soil shifts with the Tarrant County heat and drought cycles, which stresses risers and cracks heads over time — common in older systems around Interlochen, Randol Mill Heights, and the Bowen Road corridor. Arlington enforces seasonal watering rules through the city, so a head that misfires or floods a sidewalk can waste water you're paying restricted rates for. Homes near Dalworthington Gardens and the Pantego border sit on similar soil profiles. Newer builds in Viridian and The Parks at Texas Star still see head failures from mower strikes and buried debris. Local part costs match the ranges above; the $75 minimum reflects the diagnostic time to find a break underground, not a padded fee.
A dead zone usually traces to a bad solenoid, a wiring break, or a cracked valve — not always the heads. A zone test isolates which.
Most Arlington repair visits run about $75 to $250 depending on the fault, with the $75 minimum covering diagnosis and confirmation the fix runs.
A clogged head sputters or won't pop up; a broken head geysers, leans, or won't seal. Clearing a nozzle is often cheaper than replacement.
In Arlington's clay soil and heat, heads commonly last 8 to 15 years, then fail one at a time as seals and gears wear out.